Don’t display the dialog box after each drive is mapped/unmapped.
I did a macro to toggle the mapping of 6 network drives. However, I don’t want to be bothered with the dialog box that appears after each drive is mapped/unmapped. The problem is your routine for connecting the drives ends with the dialog box and the macro code is suspended until the ok button is clicked therefore precluding the macro from sending the ENTER keystroke.
If you go and edit each of the Network Toggle commands, you should see a checkbox that states “Display Connection Status”. If you uncheck this box, then you should not see any message box.
– Applies to: Macro Express and Macro Express Pro